The Register Force Status module is used to determine if a Modbus register in a SCADAPack controller is forced to some state or value, after which a bit is assigned to a status register (modbus register 10000). This status bit is user configurable. The status register is continuously updated as the Modbus register(s) in the controller get forced.

The status bit shows energized when a Modbus register(s) is/are forced and de-energized when none of the Modbus register(s) in the controller is forced. The table below outlines the states.

Xybernetics Telepace - SCADAPack Register Force Status module

Check out my vlog on SCADAPack Force Status module demonstration.

n1849778
About the
I am a software developer in Calgary, Alberta, Canada with passion in getting my fingers in any new technology. I started software development when I was 10 years old and have never looked back. Now with well over 35 years of software development, I wanted to share some of these key knowledge with the people of the world in the wide web.